Industrial

This document describes a firmware and hardware Smartcard interface solution based on the STM32F10x USART peripheral.

The SMP100 series are transient surge arrestors used for the protection of sensitive telecom equipment.

The PM6680 is a dual step-down controller with adjustable output voltages for notebook computer power systems. The PM6680 evaluation kit is designed to test the performance of the PM6680 by employing a typical application circuit that allows testing of all PM6680 device functions. The kit features two switching sections, with (typically) 1.5 V and 1.05 V outputs, from a 6 V to 28 V input battery voltage. The operating switching frequency of the two switching sections is 200 kHz / 300 kHz, respectively. Each switching section delivers more than 5 A output current. Moreover, an internal linear regulator can provide 5 V @ 100 mA peak current.

This document introduces the features and functions of the PM6680A evaluation kit, as well as the method of testing using a typical application circuit. The evaluation kit features two switching sections, providing 3.3V and 1.8V outputs from a 6V to 36V input voltage. Each switching section can deliver more than 2.5A of output current, and also includes an internal linear regulator providing a maximum 100mA of 5V output.

The SMP1000G-KQ is a Silicon P.I.N. photodiode incorporated in a hermetic metal can package.

The SMP1000G-KP is a Silicon P.I.N. photodiode incorporated in a hermetic metal can package. It has large active area and high sensitivity, but slow speed. The metal can and isolated photodiode ensure a rugged device with a high degree of immunity to conducted and radiated electrical interference.

This application note provides general guidelines for creating an IAP application. The application note describes how to use the USART protocol to run the IAP on an STM32F10x microcontroller running user firmware.

The SMP1000G-JQ is a large Silicon P.I.N. photodiode incorporated in a hermetic metal can package. The device has a greater ultra-violet light transmission, thus extending the useful spectral range. It also features high sensitivity, excellent linearity, low noise and widest spectra.

This document describes how to drive RGB LEDs, calculate power dissipation, design over temperature protection, use software PWM modulation, and implement over voltage protection for this type of application. The document also introduces the design concept of the STEVAL-ILL009V1 reference board and explains its features and characteristics.

SMP1000G-JP is a large Silicon P.I.N. photodiode produced by Semelab plc, incorporated in a hermetic metal can package. It has high sensitivity, good linearity, low noise and wide spectral response, suitable for high sensitivity light measurement applications

AN2446 application note, introduces the features and functions of STEVAL-IHT002V1 intelligent thermostat. This thermostat is based on ST7Ultralite MCU, it can drive the compressor, replace PTC and directly drive the start winding. Stall rotor detection is also implemented. Both functions are oriented to reduce the total power consumption. It can be used for small or medium compressors

This application note introduces the design of an 80 W 3-phase auxiliary power supply for motor drives and welding applications based on the L6565 and ESBT® STC04IE170HV.

This application note presents a complete design solution for a 2W single-output SMPS using the UC3845B PWM driver and the new STC04IE170 ESBT as main switch. It is associated with the release of the STEVAL-IPB001V1 demo board.