Key facts
- Brand
- Endevco
- Model
- IM7264D
- Category
- Other Electronics
- Industry
- Industrial
- Documents
- 2
- Languages
- EN
- Last added
- 2023-10-18
Start here
Endevco IM7264D Piezoresistive Accelerometer Instruction Manual
The Endevco IM7264D is a low mass, miniature piezoresistive accelerometer. The document outlines the materials required for mounting, including specific Allen wrenches and screws supplied with the unit. It emphasizes precautions such as avoiding drops and preventing over-torque during installation to avoid damaging the unit.
The manual details a check-out procedure to verify proper operation upon receipt, including impedance tests, insulation resistance checks, and zero measurand output verification. It also provides step-by-step mounting instructions, specifying surface roughness requirements and torque values, along with guidelines for cable management and recalibration intervals.
Endevco IM7264D specifications
| Type | low mass, miniature piezoresistive accelerometer |
|---|---|
| Mounting Torque | 2.6 in-lbf (0.29 N-m) recommended, 3.0 in-lbf (0.34 N-m) maximum |
| Insulation Resistance | 100 megohms minimum |
| Recommended Surface Roughness | 32 microinch rms |
| Calibration Interval | 6 to 12 month intervals |
Source: Endevco IM7264D Piezoresistive Accelerometer Instruction Manual
All Endevco IM7264D documents by type
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Questions answered in these manuals
What precautions should be observed when handling the accelerometer?
Avoid dropping the accelerometer or striking the unit against hard surfaces, and keep the protective sleeve on until the unit is installed.
From: Endevco IM7264D Piezoresistive Accelerometer Instruction Manual
What is the maximum recommended mounting torque?
The maximum recommended mounting torque is 3.0 in-lbf (0.34 N-m).
From: Endevco IM7264D Piezoresistive Accelerometer Instruction Manual
What is the recommended mounting torque for the IM7264D?
The recommended mounting torque is 2.6 in-lbf (0.29 N-m), with a maximum of 3.0 in-lbf (0.34 N-m).
From: Endevco IM7264D Piezoresistive Accelerometer Instruction Manual
What is the minimum insulation resistance for the accelerometer?
The insulation resistance between leads and shield, leads and case, and shield and case should be at least 100 megohms.
From: Endevco IM7264D Piezoresistive Accelerometer Instruction Manual