Operation guide for the Tektronix P7380 active voltage probe, covering cable handling, input limits, ESD precautions, and common failure causes.
This two-page operation guide covers handling and storage of the Tektronix P7380 series active voltage probe. It describes precautions for the probe cable, probe tip clip, soldering, input signal level, and electrostatic discharge.
The guide lists two main failure causes: one of the two 125-ohm cable conductors breaking, and ESD damage or an input signal exceeding the probe's specified input voltage. It gives preventive tips, including securing the probe to the board and wearing an anti-static wrist strap, and notes that all probes have a limited service life. This manual is written in Chinese.
| Maximum input signal | ±15 V (DC + AC peak-to-peak) |
|---|---|
| Cable conductors | Two 125-ohm cable conductors |
| ESD sensitivity | Sensitive to electrostatic discharge |
Keep the signal on the same channel within ±15 V (DC + AC peak-to-peak), and refer to the probe manual for the specified maximum input.
Use the supplied hook-and-loop fastener and tip-clip tape to fasten them to the board, which helps prevent damage from pulling the cable.
Always wear the supplied anti-static wrist strap and connect its ground wire to the host instrument or static workbench ground.
ESD damage is cumulative; several small discharges over time can lead to eventual damage, including from charge accumulated during earlier use.