This manual covers the installation, commissioning, maintenance, and specifications of the SKF Enlight Collect IMx-1 wireless condition monitoring system.
The SKF Enlight Collect IMx-1 System is a wireless architecture for condition monitoring that consists of sensors, gateways, analysis software (SKF @ptitude Observer), and a mobile application. The system allows sensors to measure vibration and temperature, pre-process signals, and transmit data wirelessly via a mesh network to the gateway.
| Radio Frequency Band | 2.4 GHz ISM band |
|---|---|
| Maximum Mesh Jumps | 10 node jumps |
| Pollution Degree | Pollution Degree 2 |
| Overvoltage Category | Category II |
| Maximum Altitude | 5,000 meters |
Please open a support case using the Technical Support group's self-help portal at www.skf.com/cm/tsg.
Relay nodes are essentially sensors with disabled measurements used to support or extend the wireless mesh network.
Yes, the sensor-gateway interface supports over-the-air (OTA) firmware updates.