Chinese installation and configuration manual for the PR electronics 4179 universal AC/DC transmitter, covering safety, mounting, wiring, specs and PR 4500…
This document is the Chinese product manual (document no. 4179V102-CN) for the PR electronics 4179 universal AC/DC transmitter from the 4000 series. The 4179 measures AC current and voltage signals and converts them to unipolar or bipolar DC current and voltage outputs, with a universal supply of 21.6...253 VAC / 19.2...300 VDC, a response time below 0.75 s and accuracy better than 0.3%. It is designed for SIL 2 applications and mounts on a DIN rail per DIN EN 60715.
The manual covers warnings and safety instructions, mounting and removal of 4000 series devices, applications and technical features, installation and commissioning, the detachable PR 4500 display/programming panel, ordering information, technical specifications, configurable input fault indication and limits, wiring diagrams, block diagrams, configuration keys and menu flow charts. Only qualified technical personnel may install and commission the product. This manual is written in Chinese.
| Operating temperature | -20°C to +60°C |
|---|---|
| Storage temperature | -20°C to +85°C |
| Relative humidity | < 95% RH (non-condensing) |
| Protection rating | IP20 |
| Dimensions (H x W x D) | 109 x 23.5 x 104 mm |
| Weight | approx. 155 g |
| Supply voltage | 21.6...253 VAC, 50...60 Hz or 19.2...300 VDC |
| Max. power consumption | ≤ 1.8 W (rated), ≤ 2.5 W (max.) |
| Isolation voltage, test | 2.3 kVAC |
| Response time | < 0.75 s |
| Accuracy | better than 0.3% |
| Signal-to-noise ratio | > 60 dB |
| Current output load | up to 800 ohm |
| DIN rail type | DIN EN 60715 - 35 mm |
Press the release button at the bottom of the PR 4500, lift it slowly upward, then pull its tab out of the hole at the top of the device.
The 4000 series must be installed on a DIN rail that complies with DIN EN 60715 (35 mm).
It has a universal supply of 21.6...253 VAC (50...60 Hz) or 19.2...300 VDC.
Yes, the 4179 is designed to strict safety requirements and is suitable for SIL 2 installations, and for systems with performance level (PL) "d" per ISO-13849.
Repairs and fuse replacement may only be carried out by PR electronics A/S.