Design manual covering layout, installation and maintenance of Netafim Techline integral dripperline using the grid layout method for subsurface and…
This Techline design manual from Netafim covers the basics of design, installation, and maintenance of Techline Integral Dripperline using the "Grid" layout method to produce a complete wetted area. The design is intended for subsurface applications but can also be applied to on-surface installations. The manual includes design steps, technical data, design layouts, and design and installation details with checklists.
The document walks through site survey, point of connection, dripper flow rate and spacing selection, supply and exhaust header layout, center feed layouts, zone water requirement calculations, and line flushing valve placement. Reference tables give row spacing recommendations, maximum lateral lengths at various inlet pressures, and flow per 100 feet of Techline for 0.4, 0.6, and 0.9 GPH drippers.
| Dripper flow rates | 0.4 GPH, 0.6 GPH, 0.9 GPH |
|---|---|
| Dripper interval | 12" to 18" depending on soil type |
| Techline lateral spacing | 12" to 24" depending on soil type and application |
| Burial depth | Bury evenly throughout the zone to a maximum of 6" |
| Header velocity limit | Maximum 5 feet per second |
| Techline header capacity | Up to 5 GPM flow |
| Line flushing valve quantity | One per 15 GPM of zone flow |
Bury evenly throughout the zone to a maximum of 6 inches; on-surface installation is also possible.
Start rows 2 inches away from hardscapes such as asphalt and 4 inches away from planting beds.
Install it in an inconspicuous area as far away from the source as possible, typically along the exhaust header, buried in a valve box with a gravel sump.
The supply header delivers water to each row of Techline and the exhaust header forms a continuous loop so all rows are supplied from both ends, which evens out flow and makes line break repairs easier.