Installation and operation manual for the Hunter MD502-12 ceiling fan, covering mounting, wiring, wall control, cleaning and troubleshooting.
This manual for the Hunter MD502-12 ceiling fan provides installation and operation instructions. It explains what to expect during installation, lists the tools needed, and describes mounting options for flat and angled ceilings, including ceiling bracket and downrod selection. Safety warnings cover disconnecting power and required clearances.
The document also covers wiring, blades, light kit and wall control installation, along with operation, maintenance and cleaning. Troubleshooting guidance addresses noisy operation, excessive wobble, a fan that does not work, and light performance issues. This manual is written in Portuguese.
| Minimum clearance from blade tip to wall or obstruction | 0.50 m |
|---|---|
| Minimum clearance from lower blade edge to floor | 2.3 m |
| Maximum ceiling angle | 34° |
| Supported fan weight | 31.8 kg |
| Mounting structure load requirement | 5 times the fan weight |
Leave at least 0.50 m from the blade tip to the nearest wall or obstruction and 2.3 m from the lower blade edge to the floor.
Yes, but the ceiling must not be angled more than 34 degrees, and a longer downrod is required for vaulted or angled ceilings.
Press and hold the Ventilador Desligado button for three seconds to start it. The lights blink, stay at 50% brightness for 15 seconds, then turn off completely after 30 seconds; CFL lights stay at 100% for 30 seconds.
Check that power is on, pull the pull chain, press the reverse switch firmly, and check the circuit breaker. Also make sure the blades turn freely and inspect the wiring connections and switch housing plug connection.