This manual provides debugging instructions for the HNC Type 8 CNC system, covering preparation, hardware connections, parameter settings, and servo tuning.
The document serves as a concise guide for debugging and configuring the HNC Type 8 numerical control (CNC) system. It covers essential procedures such as verifying equipment versions, performing offline debugging, and following step-by-step power-up principles to ensure safe operation.
Key technical sections include detailed instructions on hardware connections for milling machine systems, setting up system parameters for both moving axes and spindles, and configuring the integrated PLC (Programmable Logic Controller). The manual also addresses specific configurations like C/S axis switching, rigid tapping, tool magazine changes, and error compensation. This manual is written in Chinese.
| Input Power (160U) | Three-phase AC220V, -15%~+10%, 50/60Hz |
|---|---|
| Speed Fluctuation Rate | <±0.1 (Load 0%~100%) |
| Speed Adjustment Ratio | 1:10000 |
| Encoder Lines (Moving Axis) | 1024, 2000, 2500, or 6000 lines |
| Input Power (Spindle) | Three-phase AC380V (-15%~+10%) for 150A and below |
| Speed Control Range (Spindle) | Ratio of 1:4 constant power range |
Navigate to Diagnosis, select F10 'Version', and use the up/down keys followed by ENTER to view System Software, User Version, and Servo Drive versions.
It is recommended to disconnect the bus connection at the rear of the system before upgrading PLC or parameters to prevent standard files from overwriting existing machine-specific settings.
The system supports composite incremental encoders (1024, 2000, 2500, or 6000 lines), ENDAT2.1/2.2 absolute encoders, BISS protocol encoders, HiperFACE protocol encoders, and TAMAGAWA protocol encoders.