Quick start guide for the Freescale EVBUSB2SER USB-to-serial bridge board, covering driver installation, testing, and jumper options.
The Freescale EVBUSB2SER is a USB-to-serial bridge board for embedded systems. It supports RS232/RS485 or TTL serial data and baud rates from 300 through 115200 bps.
This guide describes Windows XP/Vista/7 and Linux driver installation, testing with HyperTerminal, and board jumper and switch options.
| Serial interface | RS232/RS485 or TTL |
|---|---|
| Baud rate | 300 through 115200 bps |
| Data bits | 8 |
| Parity | odd or even |
| Stop bits | one or two |
| Flow control | software (Xon/Xoff) and hardware |
| Board voltage | 3.3 V or 5 V |
Download the appropriate 32-bit and 64-bit installers from freescale.com/USB2SER, run the .msi file, follow the installation steps, plug in the board, and complete the hardware prompts.
Verify the COM port, open HyperTerminal with any configuration, type a key, and watch the LED indicator flash.
J3 disables RS232 and enables TTL and CMOS signals.
Download and unpack the driver files, change to root, and run Install.sh with the host distribution name.