Installation manual for Fagor 8035 CNC systems covering configuration, machine connections, parameters, PLC programming, and axis control.
This document serves as the installation and commissioning guide for the Fagor 8035 Numerical Control system. It details the setup procedures for both M-type (software version 7.1x) and T-type (software version 8.1x) configurations, addressing铣床 (milling machine) and车床 (lathe) applications respectively.
| RAM Memory | 256 Kb |
|---|---|
| PLC Cycle Time | 3ms/1000 instructions |
| Digital I/O | 40 Inputs / 24 Outputs |
| Axis Feedback Inputs | 3 TTL/1Vpp |
| Spindle Feedback Input | 1 TTL/1Vpp |
| Handwheel Feedback Inputs | 2 TTL |
| Resolution | 0.0001mm or 0.00001 inch |
| Feed Rate Range | 0.0001 to 99999.9999 mm/min |
| Processor | 32-bit with math and graphics coprocessors |
| CNC Program Memory | 256Kb |
The manual covers software version 7.1x for milling machines (M-type) and version 8.1x for lathes (T-type).
The unit should operate in an environment with relative humidity below 90% (no condensation) and temperature below 45º C.
The maximum power consumption during normal operation is approximately 48 W.