Ersa i-CON nano soldering station user manual covering commissioning, soldering, tip changes, calibration, standby, technical data and error codes.
This user manual describes the Ersa i-CON nano soldering station and i-tool nano soldering iron. It gives commissioning steps, soldering instructions, soldering-tip changes, temperature calibration, stand-by time settings, soldering-iron replacement, micro SD card settings, technical data, error codes, warranty and disposal information.
The document includes German and English instructions. It lists the scope of delivery and the technical data for the soldering station, soldering iron and holder stand. This manual is written in German.
| Station order number and power | Order No. 0IC1200A, 68 W |
|---|---|
| Operating voltage | 220–240 V ~ 50/60 Hz; 110–120 V ~ 50/60 Hz |
| Temperature range | 150–450 °C (300–840 °F) |
| Station dimensions (L x W x H) | 145 mm x 80 mm x 103 mm |
| Station weight | 1050 g |
| Soldering iron dimensions | 175 mm x 12 mm (L x handle diameter) |
| Soldering iron weight | 30 g without cable |
| Holder stand dimensions (L x W x H) | 140 mm x 80 mm x 80 mm |
| Holder stand weight | 200 g |
| Default soldering temperature | 360 °C / 680 °F |
| Temperature setting range | 150 to 450 °C / 300 to 842 °F |
| Temperature calibration range | -70 to +50 °C / -126 to +90 °F |
The scope of delivery includes an i-CON nano soldering station and an i-Tool nano soldering iron, among other items.
The default value is 360 °C / 680 °F.
The codes indicate a fault in the heating element in the soldering iron.
Only an Ersa i-tool nano soldering iron should be used.