Abracon EOL change notice for the EMRE13 series plastic SMD MEMS oscillator, with electrical specifications, pin connection and reflow data.
This 9-page document is an Engineering/Process Change Notice (ECN/PCN No. 4150) issued by Abracon for the EMRE13 Series, described as a Plastic SMD MEMS Oscillator. The change type is marked EOL and affects the whole series; the change went from Active to EOL, with the cause given as "Discontinuation of manufacturing capability." Issue date and effective date are 2/7/2022, the last time buy date is 5/7/2022, and the listed alternates are AK7 (frequency = 100 -220MHz) and AX7 (frequency greater than 220MHz or less than 100MHz).
The rest of the file holds the EMRE13 Series specification pages (Revised A: 5/11/2012, www.ecliptek.com): electrical specifications such as 1MHz to 625MHz nominal frequency, +3.3Vdc ±10% supply voltage, LVDS output logic, jitter and start-up time, plus mechanical dimensions, suggested solder pad layout, pin connection, output waveform and timing diagram, a test circuit for tri-state and complementary output, tape and reel dimensions, and recommended high- and low-temperature solder reflow profiles.
| Nominal Frequency | 1MHz to 625MHz |
|---|---|
| Supply Voltage | +3.3Vdc ±10% |
| Input Current | 45mA Typical, 55mA Maximum (excluding load termination current) |
| Output Logic Type | LVDS |
| Aging at 25°C | ±1ppm First Year Maximum |
| Start Up Time | 10mSec Maximum |
| Storage Temperature Range | -55°C to +125°C |
| Package | 6 Pad 5.0mm x 7.0mm Plastic Surface Mount (SMD) |
| Quantity per Reel | 1,000 Units |
| Moisture Sensitivity Level | Level 1 |
The stated cause is discontinuation of manufacturing capability.
The notice lists a last time buy date of 5/7/2022.
AK7 is listed for 100 -220MHz, and AX7 for frequencies greater than 220MHz or less than 100MHz.
The tape and reel section states 1,000 units per reel, compliant to EIA-481.