TPAX-Ⅲ thermal label printer adopts direct line thermal printing, with a print density of 8 points/mm, fast speed, low noise, high quality, supports thermal adhesive label printing, can automatically measure the label length and printing start position, and can print 1 inch or 2 inches wide labels.
The TP TPAX-III is a direct‑thermal label printer with 8 dots/mm density, fast printing speed and low noise. It supports thermal paper and adhesive label rolls up to 62 mm wide and can print common barcodes, characters and Chinese glyphs.
The manual provides detailed instructions for system setup, paper loading, serial interface wiring, command usage, self‑test, and print‑head cleaning, along with full command reference tables and performance specifications. This manual is written in Chinese.
| Printing method | Direct thermal line printing |
|---|---|
| Printing density | 8 dots/mm, 448 dots/line |
| Printing speed | ≈35 mm/s on normal thermal paper (25 °C) |
| Supported paper width | 62 mm (max), label width 62 mm |
| Label length range | 20–43 mm |
| Character set | IBM character set 2, 12×24 and 8×16 dots |
| Interface | Serial RS‑232C compatible, RJ‑11 4‑wire connector |
| Power supply | AC220 V / DC24 V, 2 A |
| Dimensions (W×D×H) | 100 mm × 200 mm × 160 mm |
| Weight | ≈450 g (without paper roll) |
Open the cover, remove the paper holder, place a 31 mm or 62 mm wide thermal paper or label roll on the spindle, align the paper with the feed slot and push it in until it reaches the feed rollers.
Hold down the designated key while powering on; when the paper starts feeding, release the key and the printer will print a self‑test page showing character sets, interface settings and other status information.