AT&T Vyatta 5600 vRouter 17.2.0 Bridging Configuration Guide

This document describes the Bridging Configuration Guide for AT&T Vyatta 5600 vRouter.


AT&T Vyatta 5600 vRouter 17.2.0 Bridging Configuration Guide - cover page
Brand
AT&T
Category
Other software
Document type
Programming Manual
Language
English
Pages
46
File format
PDF
File size
702 KB
Published
30 November, 2023
Updated
30 November, 2023
MD5 checksum
3DD811C964258690D2F3495E75AB9091

About this manual

This guide describes how to configure Layer 2 bridging on AT&T products that run the AT&T Vyatta Network Operating System, referred to in the document as a virtual router (vRouter). Bridging connects multiple network segments at Layer 2; because bridging occurs at the data link layer, IP addresses are not allowed on the interfaces being bridged.

The guide explains how to create a bridge group, add physical data plane or VLAN interfaces to it, and how the bridge group's effective MTU is determined. It covers Spanning Tree Protocol and Rapid Spanning Tree Protocol, including differences between the two versions, then provides basic bridging configuration examples, bridge group and bridge interface command references, supported interface types, and a list of acronyms.

What's inside

  • About This Guide
  • Bridging overview
  • Layer 2 bridging
  • MTU for bridge groups
  • Spanning Tree Protocol
  • Bridging Configuration Examples
  • Basic bridging configuration
  • Bridge Group Commands
  • Bridge Interface Commands
  • Supported Interface Types

Specifications

Effective MTU for a bridge groupThe minimum MTU of all interfaces in the bridge group
STP hello timer2 seconds
STP max age timer20 seconds (10 missed hellos)
STP forward delay timer15 seconds
RSTP topology change response timeWithin 3 x hello times (default 3 x 2 seconds), or within a few milliseconds of a physical link failure

Frequently asked questions

What does Layer 2 bridging connect?

It connects multiple network segments, typically LAN segments, at the Layer 2 level.

Are IP addresses allowed on bridged interfaces?

No. IP addresses are not allowed on the interfaces being bridged because bridging occurs at Layer 2.

What determines the effective MTU for a bridge group?

It is the minimum MTU of all the interfaces that belong to the bridge group.

Does the Vyatta vRouter support RSTP?

Yes. It supports Rapid Spanning Tree Protocol (RSTP), an enhancement of STP that provides faster convergence.

Download PDF (702 KB)

More AT&T Manuals


View all AT&T manuals →