The Dell™ EqualLogic® FS Series Appliance Installation and Setup Guide describes the maintenance and troubleshooting of customer-replaceable components for EqualLogic FS7610 appliances.
This guide explains how to install and set up the Dell EqualLogic FS7610 Series appliance, a NAS (network-attached storage) appliance in the Dell EqualLogic FS Series. It walks through pre-installation checks, rack installation, power and network cabling, NAS cluster configuration, and allocating NAS storage through NAS containers with CIFS shares and NFS exports. The document was published by Dell in October 2013 under part number YDNTN-KO A00 and is aimed at hardware administrators responsible for FS7610 hardware maintenance tasks.
The FS7610 consists of two 10Gb controllers with battery backup and two power supplies in a 2U chassis, and can be used with either SFP+ or 10GBASE-T controllers. Working with a PS Series group, it provides iSCSI block storage and NAS support from the same group; the NAS cluster network configuration uses a client network plus SAN and internal networks. This manual is written in Korean.
| Controller options | SFP+ or 10GBASE-T (not both in the same appliance) |
|---|---|
| Required PS Series firmware | 6.0 or later |
| 10GBASE-T model requirements | Firmware 7.0 and FluidFS 3.0 or later |
No. The same appliance cannot use both SFP+ and 10GBASE-T controllers.
The FS7610 requires a PS Series group running firmware version 6.0 or later. The 10GBASE-T model requires firmware version 7.0 and FluidFS version 3.0 or later.
It requires a client network and a SAN/internal network; for security the internal network is usually private and kept separate from the client network.
It is intended for hardware administrators responsible for EqualLogic FS7610 hardware maintenance tasks.