This manual provides details of MG815+ module development board EBV3, including hardware interface, software and hardware configuration, communication protocol, application development and other content. It is a reference manual for using the MG815+ module development board.
This user guide from ZTE Corporation describes how to use the MG815+ module development board EBV3, a board designed for debugging and testing ZTE CDMA and GSM modules. It is written for system designers, hardware engineers, software engineers and test engineers, and it introduces the board's characteristics, function chart and related documents before explaining the layout and the functions of each part of the board.
The guide then covers jumper settings, the debugging and testing environment, debugging steps, hyper terminal configuration and the bitmap of the module development board. Supported functions listed for the board include a power interface, serial port, UIM card interface, audio interface, LED indicator and testing sites, and jumpers let users run the board in different modes to use the functions the module provides.
| Battery input voltage (JP5) | 3.8~4.2 V steady battery |
|---|---|
| DC input voltage (JP20) | 5~6 V steady DC |
| JP5 pin 1 | Battery input (VCCBAT) |
| JP5 pin 3 | Battery voltage detection (BATSENSE) |
| JP5 pin 5 | GND |
| Basic board functions | Power interface, serial port, UIM card interface, audio interface, LED indicator, testing sites |
The guide describes two ways: a 3.8~4.2V steady battery connected through the JP5 interface, or a 5~6V steady DC supply through pin JP20. Short-circuit settings on JP5 and JP30 and the S0 switch are used to turn the board on.
Use a standard 9-core serial cable to connect serial port 1 with the PC, insert the module and antenna, turn on the board switch, then type "AT" and press Enter. If it responds "OK", the configuration has been successful.
Pressing reset button S3 on the development board resets the module. The button controls the RESET pin on the module through a transistor.
The guide gives the command AT+SPEAKER=1 as the channel switch, where 1 is earphone and 0 is handset.