This manual introduces basic operations and usage of the SDS3000 series digital oscilloscopes.
This user manual for the SIGLENT SDS3000 Series digital oscilloscope provides safety and installation information and basic operating procedures for the oscilloscope. It covers operating environment, cooling, AC power and grounding, startup, probes, and front-panel controls.
The manual also describes vertical, horizontal, and trigger settings; digital channels with the SPL3016 probe and SDS-3000-MSO software; cursor and parameter measurements; zoom, math, analysis, save/recall, and utility settings. It includes the WaveSource signal generator, which outputs six waveform types up to 25 MHz. This manual is written in Chinese.
| AC input voltage | 100–240 V rms (50/60 Hz), 100–120 V rms (400 Hz) |
|---|---|
| Maximum power consumption | 150 W (150 VA) |
| Operating temperature | 0 °C to 50 °C |
| Required ventilation clearance | At least 15 cm (6 in) on both sides, front, and rear |
| Front panel terminals | CH1, CH2, CH3, CH4, EXT |
| WaveSource output frequency | Up to 25 MHz |
| WaveSource waveform types | Sine, square, triangle, pulse, DC, and noise |
The instrument is for indoor use in a clean, dry environment with an ambient temperature range of 0 °C to 50 °C.
It runs on a single-phase 100–240 V rms, 50/60 Hz AC supply, or a 100–120 V rms, 400 Hz supply, and adapts automatically to line voltage.
Keep at least 15 cm (6 inches) of clearance at the sides, front, and rear.
It can output sine, square, triangle, pulse, DC, and noise waveforms at frequencies up to 25 MHz.