This manual describes the software driver implementation and interface for the Micrel switch
This Micrel Switch Usage Guide, Revision 1.0 dated October 30, 2014, describes how to modify the host network driver to support using the features of Micrel switches. The supported switches are KSZ8463, KSZ8863/73, KSZ9566/7 and KSZ9897 equivalents. Most switch drivers are implemented as Linux SPI drivers, with I2C drivers also available.
The guide explains that a Micrel switch is usually connected to a MAC controller through a MII/RGMII interface and is implemented as a Linux PHY device, with a virtual MDIO bus for the PHY devices. It covers Distributed Switch Architecture, host network driver modifications, switch APIs, PTP functions, hardware limitations, and the RSTP daemon.
| Supported switches | KSZ8463, KSZ8863/73, KSZ9566/7 and KSZ9897 equivalents |
|---|---|
| Host connection | MII/RGMII interface to a MAC controller |
| Register access | SPI or I2C rather than MIIM |
| Driver implementation | Linux PHY device with a virtual MDIO bus |
| Driver type | Linux SPI drivers; I2C drivers also available |
The supported switches are KSZ8463, KSZ8863/73, KSZ9566/7 and KSZ9897 equivalents.
The switch is usually connected to a MAC controller through a MII/RGMII interface.
It is accessed through SPI or I2C rather than MIIM; SPI is the faster register access mode.
It is a network layer that utilizes the switch ports as network devices and requires almost no modifications to the host network driver.