FLECK 5800 LXT Downflow/Upflow Service Manual

This document is the 5800 LXT DOWNFLOW/UPFLOW service manual, which mainly introduces the configuration method, system type, salt setting and other information of the device.


FLECK 5800 LXT Downflow/Upflow Service Manual - cover page
Brand
Fleck
Document type
Service Manual
Language
English
Pages
24
File format
PDF
File size
2.7 MB
Published
18 October, 2023
Updated
18 October, 2023
MD5 checksum
37216C6A455EC8B955609C4CE653CB88

About this manual

This service manual provides detailed instructions for installing, operating, and troubleshooting the FLECK 5800 LXT control valve for both downflow and upflow systems. It includes setup guidelines, wiring diagrams, dimensional drawings, and safety warnings. The manual also covers system configuration, meter selection, drain line sizing, and electrical requirements. Installation must comply with local plumbing and electrical codes, and the unit is designed for potable water systems only.

The document includes tables for system specifications, control programming settings, and flow data. It warns against installing the unit in freezing or high-temperature environments and emphasizes the need for proper voltage and pressure ratings. Safety precautions, such as using PTFE tape and avoiding soldering near drain fittings, are also detailed.

What's inside

  • JOB SPECIFICATION SHEET
  • INSTALLATION
  • START-UP INSTRUCTIONS/FLUSHING & CONDITIONING
  • SYSTEM DISINFECTION
  • CONTROL FEATURES
  • CONTROL OPERATION
  • MASTER PROGRAMMING MODE
  • VIEWING DIAGNOSTIC DATA / PROGRAM LOCK
  • TROUBLESHOOTING
  • 5800 LXT CONTROL VALVE ASSEMBLY

Frequently asked questions

What is the maximum water pressure rating for this unit?

The maximum pressure rating is 125 psi (8.6 bar), though daytime pressure can exceed 80 psi if a regulator is installed.

What are the minimum and maximum water temperatures for installation?

The unit must not be installed where temperatures drop below 32°F (0°C) or rise above 125°F (52°C).

What electrical supply is required for the controller?

The controller requires an uninterrupted alternating current (120 VAC) supply to operate.

Download PDF (2.7 MB)

More Fleck Manuals


View all Fleck manuals →