This document describes how to install the MAXTOR SATAII/300 Internal Hard Drive, including precautions, required tools, about Serial ATA, backing up your data, removing the system cover, mounting the hard drive, attaching Serial ATA and power cables, checking the BIOS message, formatting the hard drive, setting the boot sequence, and getting help.
This document serves as an installation guide for the Maxtor SATAII/300 Internal Hard Drive. It outlines necessary precautions before starting, lists the components included in the kit such as the hard drive, SATA interface cable, driver CD, and mounting screws, and identifies required tools like a Philips screwdriver.
The guide provides detailed instructions on removing the system cover, determining whether to install the drive in a 3.5-inch or 5.25-inch device bay, attaching Serial ATA and power cables, configuring BIOS settings for boot sequence, and formatting the hard drive.
| Capacity Unit Definition (GB) | One gigabyte, or GB, equals one billion bytes |
|---|---|
| Capacity Unit Definition (TB) | 1000 gigabytes |
Required tools include the System User Manual, Operating System CD and Boot Disk, a Philips Screwdriver, and Small Needle-Nose Pliers.
The drive should be at room temperature, you must unplug the system from the electrical outlet before connecting cables, and you should not touch the circuit board on the drive.