DISH RoadTrip Antenna System Receiver Setup Guide

About this manual

This guide provides steps to clear existing receiver settings before turning on a DISH receiver connected to a Winegard RoadTrip antenna system. It includes specific instructions for disconnecting cables, navigating the menu system, and running diagnostic tests.

The document details how to verify the installation of the SW64 switch within the receiver software, which is required for proper operation with these antennas. It also notes compatibility requirements regarding hard drives and recommends using standard DISH receivers.

What's inside

• Clearing Receiver Settings
• Menu Navigation
• Check Switch Test
• SW64 Installation Verification
• System Compatibility

Frequently asked questions

How long should I wait for the antenna to acquire satellites after turning it on?

Allow the antenna 3-4 minutes to acquire satellites.

What is the delay before an In-Motion or Tracking system enters Sleep Mode after a search?

The system will take another 6 minutes before going into Sleep Mode.

Which DISH receiver series may require checking boxes for Superdish and Alternate settings?

You may need to check these boxes if setting up a DISH 311, 301, or 500 series receiver.