AN-3001 is an application note about optocoupler input drive circuits from Fairchild Semiconductor
The document explains the operating principles of optocouplers, focusing on the infrared LED input characteristics such as forward bias current, voltage, and junction capacitance. It details the exponential increase in current above a 1-volt threshold and the need for current-mode driving rather than voltage driving to ensure proper operation.
The text provides specific circuit designs for different applications, including methods for adjusting the LED threshold using shunt resistors, protecting the LED from reverse breakdown, and driving the LED from AC mains sources. It also covers logic-to-logic interfaces using transistor drive circuits and techniques for boosting current capability when the driving logic cannot sink the necessary current.
| Forward bias current threshold | approximately 1 volt |
|---|---|
| Useful range of Ip | between 1 mA and 100 mA |
| Forward voltage range | between 1.2 and 1.3 volts |
| Reverse leakage current | nanoampere range |
| Inherent delay for fast pulse conditions | 10-20 nanoseconds or more |
| Forward voltage temperature coefficient | 1.05 mV/°C |
| Failure point for brightness degradation | 50% degradation |
The device should always be driven in a current mode, not voltage driven, because the current increases very rapidly above threshold.
A silicon diode installed inversely parallel to the LED is the simplest method of achieving this protection.
The threshold can be obtained by shunting the LED with a resistor, where the value is determined by a ratio between the applied voltage, the series resistor, and the desired threshold.
A 50% degradation is considered to be the failure point, which must be considered in the initial design of optoisolator circuits.