D-Link DES-3028/DES-3028P/DES-3052/DES-3052P Managed Switch CLI Reference Manual

Q: How do I set the switch’s IP address via the CLI?

Use the command `config ipif System ipaddress / ` (e.g., `config ipif System ipaddress 10.98.90.91/8`).

This document introduces the CLI Reference Manual of D-Link DES-3028/DES-3028P/DES-3052/DES-3052P Managed 10/100Mbps Fast Ethernet Switch

D-Link DES-3028/DES-3028P/DES-3052/DES-3052P Managed Switch CLI Reference Manual - cover page

Brand: D-Link
Category: Network Switches
Document type: Programming Manual
Language: Chinese
Pages: 250
File format: PDF
File size: 5.2 MB
Published: 13 March, 2012
Updated: 30 September, 2023
Models: DES-3028, DES-3028P, DES-3052, DES-3052P
MD5 checksum: B7A49AE6D2BEA4BBF8656973D3561917
PDF: D-Link DES-3028/DES-3028P/DES-3052/DES-3052P Managed Switch CLI Reference Manual PDF

About this manual

The D-Link DES-3028, DES-3028P, DES-3052 and DES-3052P are Layer‑2 Fast Ethernet switches that can be managed via a serial console, Telnet or the web‑based management agent. This programming manual provides a complete reference of all command‑line interface (CLI) commands for configuring and monitoring the switches.

The manual covers console access, IP address configuration, VLAN, spanning‑tree, PoE, security, and many other features. It also includes technical specifications such as power requirements, switching capacity, port counts and supported standards. This manual is written in Chinese.

What's inside

Introduction
Using the Console CLI
Command Syntax
Basic Switch Commands
Port Security Commands
Network Management (SNMP) Commands
VLAN Commands
Link Aggregation Commands
Basic IP Command
Technical Specifications

Specifications

Power Input	100‑240 VAC, 50‑60 Hz
Switching Capacity (DES‑3028/3028P)	12.8 Gbps
Packet Buffer Memory	4 Mbits
MAC Address Table Size	8 K entries
10/100Base‑T Ports	24 (non‑PoE) or 48 (PoE) ports
Combo 1000BASE‑T/SFP Ports	2 ports

Frequently asked questions

What is the default IP address of the switch?

The default IP address is 10.90.90.90.

How do I set the switch’s IP address via the CLI?

Use the command `config ipif System ipaddress /` (e.g., `config ipif System ipaddress 10.98.90.91/8`).

What are the serial port default settings for console access?

9600 baud, no parity, 8 data bits, 1 stop bit.

Download PDF (5.2 MB)