EMC NetWorker Release 7.6 Service Pack 1 Installation Guide P/N 300-011-324 REV A02

About this manual

This guide provides detailed instructions for installing or upgrading EMC NetWorker Release 7.6 Service Pack 1 on supported client, storage node, server, and console platforms. It includes software prerequisites, platform‑specific steps for AIX, HP‑UX, Linux, Windows, Mac OS X, Solaris and other UNIX variants, and post‑installation verification.

The document also describes how to configure devices, add servers to the NetWorker Console, and perform a test backup to confirm a successful installation. It is intended for system administrators responsible for NetWorker deployments.

What's inside

• Introduction
• Software Requirements
• Getting Started
• Platform‑Specific Installation (AIX, HP‑UX, Linux, Windows, Mac OS X, Solaris)
• Update from a Previous Release
• Device Configuration
• Verify the Installation
• Console Administration

Specifications

Frequently asked questions

What should I do if the JRE is not installed on the system?

The installation will display a prompt to install the appropriate JRE version; follow the on‑screen instructions to complete the installation.

How do I verify that the NetWorker installation succeeded?

Run the test backup procedures described in the Verify the Installation chapter, such as starting the Console, adding a server, configuring a device, and performing an ad‑hoc backup.