Yaskawa FS100 Error 4220: SERVO POWER OFF FOR JOB

Yaskawa FS100 · taken from the manufacturer’s manual, pages cited

Error code4220

The servo power for the job has been turned off due to a setting error. The manual's first action is: “(1)Check the following settings. - Turn OFF the servo power supply, and then turn ON the servo power supply for the group axis to be operated.”

Model
Yaskawa FS100
Display shows
SERVO POWER OFF FOR JOB (4220)
Type
Error code
Source
Manual p. 213

What 4220 means

SERVO POWER OFF FOR JOB p. 213

Common causes

What to do

  1. (1)Check the following settings. - Turn OFF the servo power supply, and then turn ON the servo power supply for the group axis to be operated. p. 213

If 4220 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Yaskawa service.

Open the manual at page 213 All FS100 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 4220; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.