Error code100
The system detected an invalid serial communication watchdog counter value from the servo control board. The manual's first action is: “(1)Check the following settings. The serial port setting”
- Model
- Yaskawa FS100
- Display shows
- Setting error (100)
- Type
- Error code
- Source
- Manual p. 213
What 100 means
Setting error p. 213
Common causes
- Setting error p. 213
What to do
- (1)Check the following settings. The serial port setting p. 213
If 100 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Yaskawa service.
This page summarises what the manufacturer’s manual says about 100; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.