Yaskawa FS100 Error 94: H A function error (conv_pulse_to_angle())

Yaskawa FS100 · taken from the manufacturer’s manual, pages cited

Alarm code94

H A function error (conv_pulse_to_angle()) occurred due to a software operation error. The manual's first action is: “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure).”

Model
Yaskawa FS100
Display shows
H A function error (conv_pulse_to_angle()) (94)
Type
Alarm code
Source
Manual p. 195

What 94 means

H A function error (conv_pulse_to_angle()) p. 195

Common causes

  • Software operation error occurred p. 195

What to do

  1. (1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 195

If 94 is still not resolved

  • (1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 195
    “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure).”
Open the manual at page 195 All FS100 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 94; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.