Yaskawa FS100 Error 103: Setting error

Yaskawa FS100 · taken from the manufacturer’s manual, pages cited

Error code103

The system detected an illegal data length in transmission requests. The manual's first action is: “(1)Check the following settings. - RS157 . . Set to 1 to 4”

Model
Yaskawa FS100
Display shows
Setting error (103)
Type
Error code
Source
Manual p. 213

What 103 means

Setting error p. 213

Common causes

What to do

  1. (1)Check the following settings. - RS157 . . Set to 1 to 4 p. 213

If 103 is still not resolved

  • Turn the power OFF then back ON. (2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 171
    “Turn the power OFF then back ON. (2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and then contact your Yaskawa representativ e about occurrence status (operating procedure).”
  • Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 196
    “Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and then contact your Yaskawa representativ e about occurrence status (operating procedure).”
Open the manual at page 213 All FS100 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 103; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.