TMS7 ME00070B Error 9: Undercurrent trip

TMS7 soft starter · taken from the manufacturer’s manual, pages cited

Fault code9

The TMS7 has measured a run current lower than the limit set in Function 8. Undercurrent Protection. The manual's first action is: “1. Identify and correct the cause of the undercurrent event.”

Model
TMS7 ME00070B
Display shows
Undercurrent trip (9)
Type
Fault code
Source
Manual p. 29

What 9 means

Undercurrent trip p. 29

Common causes

  • The TMS7 has measured a run current lower than the limit set in Function 8. Undercurrent Protection. p. 29

What to do

  1. 1. Identify and correct the cause of the undercurrent event. p. 29

Before you service the product, read the safety instructions in the manual p. 3.

If 9 is still not resolved

  • 1. Identify and correct the cause of the undercurrent event. p. 29
    “1. Identify and correct the cause of the undercurrent event.”

This page summarises what the manufacturer’s manual says about 9; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with TMS7. Found a mistake? Report an error.