TMS7 ME00070B Error 2: Overcurrent trip

TMS7 soft starter · taken from the manufacturer’s manual, pages cited

Fault code2

The motor has been overloaded and its thermal limit has been reached. The manual's first action is: “1. Remove the cause of the overload and let the motor cool before restarting.”

Model
TMS7 ME00070B
Display shows
Overcurrent trip (2)
Type
Fault code
Source
Manual p. 29

What 2 means

Overcurrent trip p. 29

Common causes

  • The motor has been overloaded and the motor's thermal limit, as calculated by the TMS7 motor thermal model, has been reached. p. 29

Safety warnings — read before you start

  • CAUTIONCAUTION. WARNING - ELECTRICAL SHOCK HAZARD The TMS7 contains dangerous voltages when connected to line voltage. Only a competent electrician should carry out the electrical installation. p. 3

What to do

  1. 1. Remove the cause of the overload and let the motor cool before restarting. p. 29

If 2 is still not resolved

  • 1. Remove the cause of the overload and let the motor cool before restarting. p. 29
    “1. Remove the cause of the overload and let the motor cool before restarting.”
Open the manual at page 29 All ME00070B error codes Manual details & download

This page summarises what the manufacturer’s manual says about 2; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with TMS7. Found a mistake? Report an error.