TMS7 ME00070B Error 7: Stall trip

TMS7 soft starter · taken from the manufacturer’s manual, pages cited

Fault code7

The TMS7 has detected a current equal to the limit set in Function 9. Stall Protection. The manual's first action is: “1. Identify and correct the cause of the instantaneous overload event.”

Model
TMS7 ME00070B
Display shows
Stall trip (7)
Type
Fault code
Source
Manual p. 29

What 7 means

Stall trip p. 29

Common causes

  • The TMS7 has measured a current equal to the limit set in Function 9. Stall Protection. p. 29

What to do

  1. 1. Identify and correct the cause of the instantaneous overload event. p. 29

Before you service the product, read the safety instructions in the manual p. 3.

If 7 is still not resolved

  • 1. Identify and correct the cause of the instantaneous overload event. p. 29
    “1. Identify and correct the cause of the instantaneous overload event.”

This page summarises what the manufacturer’s manual says about 7; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with TMS7. Found a mistake? Report an error.