Rockwell Automation MicroLogix 1400 Error xx8c(102): EXPANSION I/O OBJECT TYPE MISMATCH

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error codexx8c(102)

An expansion I/O object (that is cable, power supply, or module) in the user program I/O configuration is not the same object type as is physically present. The manual's first action is: “Correct the user program I/O configuration so that the object types match the actual configuration, and Recompile, reload the program, and enter the Run mode, Or Correct the actual configuration to match the user program I/O configuration. Cycle power.”

Model
Rockwell Automation MicroLogix 1400
Display shows
EXPANSION I/O OBJECT TYPE MISMATCH (xx8c(102))
Type
Error code
Source
Manual p. 405

What xx8c(102) means

EXPANSION I/O OBJECT TYPE MISMATCH p. 405

Common causes

  • An expansion I/O object (that is cable, power supply, or module) in the user program I/O configuration is not the same object type as is physically present. p. 405

What to do

  1. Correct the user program I/O configuration so that the object types match the actual configuration, and Recompile, reload the program, and enter the Run mode, Or Correct the actual configuration to match the user program I/O configuration. Cycle power. p. 405

Before you service the product, read the safety instructions in the manual p. 274.

If xx8c(102) is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about xx8c(102); each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.