Rockwell Automation MicroLogix 1400 Error 84: Slave Device Failure

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code84

An unrecoverable error occurred while the slave attempted to perform the requested action. The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
Slave Device Failure (84)
Type
Error code
Source
Manual p. 427

What 84 means

Slave Device Failure p. 427

Common causes

  • An unrecoverable error occurred while the slave was attempting to perform the requested action. p. 427

If 84 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 84; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.