Rockwell Automation MicroLogix 1400 Error xx8a(102): EXPANSION I/O CABLE CONFIGURATION MISMATCH ERROR

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error codexx8a(102)

Either an expansion I/O cable is configured in the user program, but no cable is present, or an expansion I/O cable is configured in the user program and a cable is physically present, but the types d The manual's first action is: “Correct the user program to eliminate a cable that is not present. Recompile, reload the program and enter the Run mode, or Cycle power.”

Model
Rockwell Automation MicroLogix 1400
Display shows
EXPANSION I/O CABLE CONFIGURATION MISMATCH ERROR (xx8a(102))
Type
Error code
Source
Manual p. 405

What xx8a(102) means

EXPANSION I/O CABLE CONFIGURATION MISMATCH ERROR p. 405

Common causes

  • Either an expansion I/O cable is configured in the user program, but no cable is present, or an expansion I/O cable is configured in the user program and a cable is physically present, but the types do not match. p. 405

What to do

  1. Correct the user program to eliminate a cable that is not present. Recompile, reload the program and enter the Run mode, or Cycle power. p. 405

Before you service the product, read the safety instructions in the manual p. 274.

If xx8a(102) is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about xx8a(102); each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.