Rockwell Automation MicroLogix 1400 Error 82: Illegal Data Address

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code82

The data address referenced in the Master command does not exist or access to it is denied on the slave. The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
Illegal Data Address (82)
Type
Error code
Source
Manual p. 427

What 82 means

Illegal Data Address p. 427

Common causes

  • The data address that is referenced in the Master command does not exist in the slave, or access to that address is not allowed. p. 427

If 82 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 82; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.