Rockwell Automation MicroLogix 1400 Error 10H

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code10H

Target node cannot respond because of incorrect command parameters or unsupported command means the command sent is invalid or not supported by the target node. The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
10H
Type
Error code
Source
Manual p. 310

What 10H means

Target node cannot respond because of incorrect command parameters or unsupported command. p. 310

Common causes

  • Target node cannot respond because of incorrect command parameters or unsupported command. p. 310

If 10H is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 10H; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.