Rockwell Automation MicroLogix 1400 Error 0CH

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code0CH

Received a master link reset (one possible source is from the DF1 master) means a master link reset occurred, possibly initiated by the DF1 master. The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
0CH
Type
Error code
Source
Manual p. 310

What 0CH means

Received a master link reset (one possible source is from the DF1 master). p. 310

Common causes

  • Received a master link reset (one possible source is from the DF1 master). p. 310

If 0CH is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 0CH; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.