Rockwell Automation MicroLogix 1400 Error 0051: BASE TYPE MISMATCH

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code0051

A particular hardware type (AWA, BWA, BXB, AWAA, BWAA, BXA) was selected in the user program configuration, but did not match the actual base. The manual's first action is: “Connect to the hardware that is specified in the user program, or Reconfigure the program to match the attached hardware.”

Model
Rockwell Automation MicroLogix 1400
Display shows
BASE TYPE MISMATCH (0051)
Type
Error code
Source
Manual p. 404

What 0051 means

BASE TYPE MISMATCH p. 404

Common causes

  • A particular hardware type (AWA, BWA, BXB, AWAA, BWAA, BXA) was selected in the user program configuration, but did not match the actual base. p. 404

What to do

  1. Connect to the hardware that is specified in the user program, or Reconfigure the program to match the attached hardware. p. 404

Before you service the product, read the safety instructions in the manual p. 274.

If 0051 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 0051; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.