Rockwell Automation MicroLogix 1400 Error 003D: INVALID SEQUENCER LENGTH/POSITION

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code003D

A sequencer instruction (S00, SOC, SOL) length/position parameter is greater than 255. The manual's first action is: “Correct the user program, then recompile, reload the program, and enter the Run mode.”

Model
Rockwell Automation MicroLogix 1400
Display shows
INVALID SEQUENCER LENGTH/POSITION (003D)
Type
Error code
Source
Manual p. 404

What 003D means

INVALID SEQUENCER LENGTH/POSITION p. 404

Common causes

  • A sequencer instruction (S00, SOC, SOL) length/position parameter is greater than 255. p. 404

What to do

  1. Correct the user program, then recompile, reload the program, and enter the Run mode. p. 404

Before you service the product, read the safety instructions in the manual p. 274.

If 003D is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 003D; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.