Rockwell Automation MicroLogix 1400 Error 003F: COP/CPW/FLL OUTSIDE OF DATA FILE SPACE

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code003F

A COP, CPW, or FLL instruction length parameter references outside of the entire data space. The manual's first action is: “Correct the program to ensure that the length and parameter do not point outside of the data file space. Recompile, reload the program, and enter the Run mode.”

Model
Rockwell Automation MicroLogix 1400
Display shows
COP/CPW/FLL OUTSIDE OF DATA FILE SPACE (003F)
Type
Error code
Source
Manual p. 404

What 003F means

COP/CPW/FLL OUTSIDE OF DATA FILE SPACE p. 404

Common causes

  • A COP, CPW, or FLL instruction length parameter references outside of the entire data space. p. 404

What to do

  1. Correct the program to ensure that the length and parameter do not point outside of the data file space. Recompile, reload the program, and enter the Run mode. p. 404

Before you service the product, read the safety instructions in the manual p. 274.

If 003F is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 003F; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.