Rockwell Automation MicroLogix 1400 Error 0052: MINIMUM SERIES ERROR

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code0052

The hardware minimum series that is selected in the user program configuration was greater than the series on the actual hardware. The manual's first action is: “Connect to the harware that is specified in the user program, or Reconfigure the program to match the attached hardware.”

Model
Rockwell Automation MicroLogix 1400
Display shows
MINIMUM SERIES ERROR (0052)
Type
Error code
Source
Manual p. 404

What 0052 means

MINIMUM SERIES ERROR p. 404

Common causes

  • The hardware minimum series that is selected in the user program configuration was greater than the series on the actual hardware. p. 404

What to do

  1. Connect to the harware that is specified in the user program, or Reconfigure the program to match the attached hardware. p. 404

Before you service the product, read the safety instructions in the manual p. 274.

If 0052 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 0052; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.