Rockwell Automation MicroLogix 1400 Error 0050: CONTROLLER TYPE MISMATCH

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code0050

A particular controller type was selected in the user program configuration, but did not match the actual controller type. The manual's first action is: “Connect to the hardware that is specified in the user program, or Reconfigure the program to match the attached hardware.”

Model
Rockwell Automation MicroLogix 1400
Display shows
CONTROLLER TYPE MISMATCH (0050)
Type
Error code
Source
Manual p. 404

What 0050 means

CONTROLLER TYPE MISMATCH p. 404

Common causes

  • A particular controller type was selected in the user program configuration, but did not match the actual controller type. p. 404

What to do

  1. Connect to the hardware that is specified in the user program, or Reconfigure the program to match the attached hardware. p. 404

Before you service the product, read the safety instructions in the manual p. 274.

If 0050 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 0050; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.