Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Error factory default setting occurs when resetting to factory defaults fails. The manual's first action is: “Please operate once again”
Error setting of parameter batch occurs when batch parameter settings fail. The manual's first action is: “Please operate once again”
Error parameters calibration happens when special parameter storage fails. The manual's first action is: “If the encoder is HEIDENHAIN encoder, please check EC. 32.If EC. 32 is not stored successfully, The zero needs …
Error parameters storage occurs when parameter attribution changed, deleted, or became unavailable. The manual's first action is: “Please reset the corresponding parameters”
EEPROM is interrupted, indicating a communication or power interruption during EEPROM operation. The manual's first action is: “Please reset the corresponding parameters”
EEPROM is erased, meaning the EEPROM has been cleared. The manual's first action is: “Please reset the corresponding parameters”
Version changes occur when current EEPROM parameters are incompatible with DSP version parameters. The manual's first action is: “Please reset the relevant parameters”
Timeout of EEPROM occurs because EEPROM is damaged. The manual's first action is: “Seek for technical support”
Encoder 2 error happens when mechanical angle exceeds reference angle in encoder 2. The manual's first action is: “1. Checking the wiring 2. Exclude the interference”
Emulation encoder error occurs if FPAs is damaged or stimulated signal doesn't match the source angle variation. The manual's first action is: “1. Check whether the stimulated card has been refreshed. 2. Check whether…
External error happens when one of DI.02 to DI.07 is set 13 and the IO receives a signal. The manual's first action is: “Check the signal source, clear the error”
Encoder initialization fails due to abnormal communication or bad EMC environment. The manual's first action is: “1.Check the wiring 2.Improve EMC environment 3.To seek for technical support”
Non-finished notch position self-searching because the previous search hasn't completed. The manual's first action is: “Clean the error, do notch position searching once again”
Encoder error from loosened or disconnected wiring or internal wiring fault. The manual's first action is: “1.Check the encoder wiring connection 2.Seek for technical support”
Abnormal FPGA communication due to possible FPGA damage. The manual's first action is: “Seek for technical support”