Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
An incorrect PIN or a locked SIM card caused access failure. The manual lists no action for this code.
The modem did not respond as expected during operation. The manual lists no action for this code.
A message could not be transmitted through the serial port. The manual lists no action for this code.
The system failed to open the serial port for communication. The manual lists no action for this code.
All 15 error codes of the Indusoft GSM/SMS and GPRS/FTP drivers GSM/SMS and GPRS/FTP drivers with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
Something unusual was detected with the disc while recording, playback or copy when a disc is inserted. The manual's first action is: “This is displayed when the unit is in the recovery process to return to normal ope…
The unit fails to operate properly. The manual's first action is: “Press [△/□] on the main unit to switch the unit to standby mode. Now press [○/△] on the main unit again to turn the unit on.”
The unit fails to operate properly. The manual's first action is: “Press [△/□] on the main unit to switch the unit to standby mode. Now press [○/△] on the main unit again to turn the unit on.”
The unit fails to operate properly. The manual's first action is: “Press [△/□] on the main unit to switch the unit to standby mode. Now press [○/△] on the main unit again to turn the unit on.”
HDMI cannot be output because you are connected to a model that does not support copyright protection. The manual lists no action for this code.
A malfunction has occurred during recording, playback or copy when a disc is not inserted. The manual's first action is: “This is displayed when the unit is in the recovery process to return to normal operation; it is…
The unit is hot. The manual's first action is: “The unit switches to standby for safety reasons. Wait for about 30 minutes until the message disappears. Select a position with good ventilation when installing the unit…
The HDMI connection could not be authenticated due to an internal data malfunction. The manual's first action is: “Consult the dealer where the unit was purchased.”
The HDMI connection could not be authenticated due to a transfer malfunction. The manual's first action is: “Consult the dealer where the unit was purchased.”
Available space on the HDD or disc. The manual's first action is: “The example "SP 35:50" is displayed when less than 100 hours are available and the example "LP 151h" is displayed when over 100 hours are available. "…