Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
PROFIdrive: Receive configuration data invalid due to a consistency error detected during configuration activation. The manual's first action is: “Check the required interface configuration, correct if necessary.”
PROFIdrive: No cyclic connection because there is no active cyclic connection to the control system. The manual's first action is: “Establish the cyclic connection and activate the control with cyclic operation.”
PROFIdrive: Receive configuration data invalid when the drive unit did not accept received configuration data. The manual's first action is: “Check the receive configuration data.”
Motor data identification active because the motor data identification routine is running and will complete on next power-on or restart. The manual's first action is: “The alarm automatically disappears after the moto…
Angular commutation offset determination activated as automatic encoder adjustment is being performed at next power-on. The manual's first action is: “The alarm automatically disappears after determination.”
Save required because the angular commutation offset was re-defined but not saved permanently. The manual's first action is: “This alarm automatically disappears after the data has been saved.”
Power unit overload I²t when the alarm threshold for power unit overload has been exceeded. The manual's first action is: “Reduce the continuous load.”
EPOS: Software limit switch plus reached when the axis has reached the software limit switch plus position while an active traversing block was interrupted. The manual's first action is: “Correct the target position. …
EPOS: Software limit switch minus reached when the axis has reached the software limit switch minus position while an active traversing block was interrupted. The manual's first action is: “Correct the target position.”
EPOS: Target position > software limit switch plus when the target position is greater than the software limit switch plus during traversal. The manual's first action is: “Correct the target position.”
EPOS: Target position < software limit switch minus when the target position is less than the software limit switch minus during traversal. The manual's first action is: “Correct the target position.”
EPOS: End of traversing range reached when the axis has moved to the traversing range limit during traversal. The manual's first action is: “Move away in the negative direction.”
EPOS: Beginning of traversing range reached when the axis has moved to the traversing range limit during traversal. The manual's first action is: “Move away in the positive direction.”
ABS_POS or ABS_NEG positioning mode is parameterized without modulo correction enabled, making it impossible for EPOS operation. The manual's first action is: “Correct the traversing block.”
The target position in a traversing block lies outside the modulo range and must be corrected to remain within valid limits. The manual's first action is: “In the traversing block, correct the target position.”