Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
A positioning error occurred during sequential movement of the tape. The manual lists no action for this code.
There is an error in the tape length detected by the device. The manual lists no action for this code.
The medium's format has been corrupted. The manual lists no action for this code.
The medium cannot be read because it uses an incompatible format. The manual lists no action for this code.
The installed medium is not compatible with this device. The manual lists no action for this code.
A positioning error was detected while reading the medium. The manual lists no action for this code.
An error occurred in the sequence of blocks being read. The manual lists no action for this code.
The end of the data was not found during a read operation. The manual lists no action for this code.
The device failed to fully read a block of data. The manual lists no action for this code.
A read error occurred that could not be recovered. The manual lists no action for this code.
There was an error writing data to the medium. The manual lists no action for this code.
The device has detected the end of a partition or medium. The manual lists no action for this code.
All 19 error codes of the Sony SDT-9000 tape drive with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
A ground fault current exceeding the programmed "GF" value has been detected, requiring manual reset and motor inspection. The manual's first action is: “A manual reset is required. Check the motor for insulation brea…
The overload relay tripped on a fault and is timing down "RD3" before restarting. The manual's first action is: “If undercurrent is not a normal condition for this installation, check for broken shafts, broken belts, …