Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Power interruption during bath fill means water will not flow when power returns after a shutdown. The manual's first action is: “Press ON/OFF twice.”
All 8 error codes of the Rinnai RUR199e / RUR160e / RUR199i / RUR160i tankless water heater with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
Either the media or ribbon is not properly loaded or is missing. The manual lists no action for this code.
An RS232 communication error has been detected. The manual lists no action for this code.
The device's memory is full and cannot accept more data. The manual lists no action for this code.
A bar code data error occurred during processing. The manual lists no action for this code.
The device encountered an issue parsing a command. The manual lists no action for this code.
All 5 error codes of the Argox PPLA/PPLB label printer with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
Emergency missing because servo operation is disabled when the emergency input (EMGS) is switched off. The manual's first action is: “Switch on the emergency input (EMGS) and then implement servo on.”
Braking resistor reaches alarm threshold when the braking resistor’s heat capacity has reached its capacity threshold. The manual's first action is: “Change the external braking resistor.”
Failure during data copying because copying was halted, possibly due to micro SD card removal or drive not being stopped. The manual's first action is: “Re-plug in the micro SD card/SD card.”
Error bit set in the serial protocol when the encoder sends an error bit via the serial protocol. The manual's first action is: “Carry out a POWER ON (power off/on) for all components.”
Encoder 1: Absolute encoder signals Internal alarms because the absolute encoder fault word includes set alarm bits. The manual's first action is: “Check the encoder cable connection and make sure the cables are route…
Hardware current limiting in phase U when hardware current limit for phase U has responded, possibly due to incorrect parameterization or motor/power cable fault. The manual's first action is: “Check the motor data. A…
Load supply switched off because the DC link voltage is too low. The manual's first action is: “Switch on the load supply.”