Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Voltage required for lighting has decreased too much. The manual's first action is: “Check for aging of lighting or a failed LED”
Voltage required for lighting has increased too much. The manual's first action is: “Check for aging of lighting or a failed LED”
Output is short circuit. The manual lists no action for this code.
Output current to lighting is too low. The manual lists no action for this code.
Internal power dissipation is too high. Output turned off. The manual lists no action for this code.
Can’t read Ethernet settings from EEPROM, so these maybe incorrect. The manual lists no action for this code.
Can’t save settings to EEPROM. The manual lists no action for this code.
EEPROM corrupt. Configuration has been cleared. The manual lists no action for this code.
(Warning only) A timing parameter was out of range and has been adjusted. The manual's first action is: “For example, sending an RT command with a delay of 0 will get a reply of “Err 5”. When settings are viewed delay…
Wrong number of parameters. The manual lists no action for this code.
Numeric value is wrong format. The manual lists no action for this code.
Command not recognised. The manual lists no action for this code.
A parameter value is invalid. The manual lists no action for this code.
All 17 error codes of the JM Vistec DLC-C2P6-D-E LED Current Controller with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
The hardware configuration is incompatible with the system. The manual lists no action for this code.