Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
CPU Temperature is too high The manual lists no action for this code.
Printer Not Available The manual lists no action for this code.
Hardcopy not possible during measurement sequence The manual's first action is: “In such cases synchronization to the end of the scan sequence should be performed prior to starting the printout.”
Tracking LO is Unlocked The manual lists no action for this code.
Trigger-Block Gate Delay Error- gate length < Gate Delay The manual lists no action for this code.
Frontend LO is Unlocked The manual lists no action for this code.
The firmware version is out-of-date and does not support the currently installed hardware. Until the firmware version is updated, this error message is displayed and self-alignment fails. The manual's first action is:…
One of the following conditions applies: Correction data has been switched off. No correction values are available, for example after a firmware update. Record the correction data by performing a self The manual's fir…
OCXO reference frequency (option R&S FSW-B4) has not yet reached its operating temperature. The message usually disappears a few minutes after power has been switched on. The manual lists no action for this code.
Error in the instrument's frequency processing hardware was detected. The manual lists no action for this code.
All 10 error codes of the Rohde & Schwarz FSW signal and spectrum analyzer with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
Internal error. The Meter must be repaired before it will operate. The manual lists no action for this code.
Internal error. The Meter must be repaired before it will operate. The manual lists no action for this code.
Calibration required. Meter calibration is required before the Meter will operate. The manual lists no action for this code.
Battery must be replaced before the Meter will operate. The manual lists no action for this code.