Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Travel limit overrun error 150 occurs when the axis movement exceeds preset travel limits, requiring recheck of limit values and programming. The manual's first action is: “Check the values of these limits and the pro…
Overvoltage at digital inputs error 109 occurs when input voltage exceeds configured limits, requiring parameter check and voltage verification. The manual's first action is: “Check the configuration (parameter IP5 -F…
Motor overtemperature error 108 is triggered by defective temperature sensors or high current peaks, requiring system pause and ventilation. The manual's first action is: “Stop the system for a few minutes and decreas…
Drive overtemperature error 107 occurs when the drive’s ambient temperature exceeds safe limits and must be lowered. The manual's first action is: “It must be lowered.”
Error 106 indicates the drive is overheating due to excessive load or ambient temperature on the heatsink. The manual's first action is: “Stop the system for a few minutes and reduce the amount of effort required of t…
Internal -18 Voltage out of range error 105 has occurred without specified cause in this product's documentation. The manual lists no action for this code.
Internal +18 Voltage out of range error 104 has occurred without specified cause in this product's documentation. The manual lists no action for this code.
Internal -8 Voltage out of range error 103 has occurred without specified cause in this product's documentation. The manual lists no action for this code.
Internal +8 Voltage out of range error 102 has occurred without specified cause in this product's documentation. The manual lists no action for this code.
Internal -5 Voltage out of range error 101 has occurred without specified cause in this product's documentation. The manual lists no action for this code.
Internal +5 Voltage out of range error 100 has occurred without specified cause in this product's documentation. The manual lists no action for this code.
Error 6 on the Sercos board requires replacing the board; if persistent, replace the Vecon card. The manual's first action is: “Change the board. If the error persists, change the Vecon card.”
Code Checksum Error 5 indicates the loaded program's checksum is invalid, possibly due to corrupted software or memory issues. The manual's first action is: “Reload the software. If the problem persists, the Flash or …
Emergency stop error 4 occurs when the motor cannot be stopped within the GP3 time limit despite maximum torque application. The manual's first action is: “The load to be stopped by the motor is too great for the time…
Error 3 indicates a voltage drop at the Power Bus while torque is being applied, likely due to line or drive failure. The manual's first action is: “Check the proper condition of the lines and the drives and restart t…